RHEL 8 must prevent IPv6 Internet Control Message Protocol (ICMP) redirect messages from being accepted.

STIG ID: RHEL-08-040210  |  SRG: SRG-OS-000480-GPOS-00227 |  Severity: medium |  CCI: CCI-000366 |  Vulnerability Id: V-230535 | 

Vulnerability Discussion

ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages modify the host's route table and are unauthenticated. An illicit ICMP redirect message could result in a man-in-the-middle attack.

Check

Verify RHEL 8 will not accept IPv6 ICMP redirect messages.

Note: If IPv6 is disabled on the system, this requirement is Not Applicable.

Check the value of the default "accept_redirects" variables with the following command:

$ sudo sysctl net.ipv6.conf.default.accept_redirects

net.ipv6.conf.default.accept_redirects = 0

If the returned line does not have a value of "0", a line is not returned, or the line is commented out, this is a finding.

Fix

Configure RHEL 8 to prevent IPv6 ICMP redirect messages from being accepted with the following command:

$ sudo sysctl -w net.ipv6.conf.default.accept_redirects=0

If "0" is not the system's default value then add or update the following line in the appropriate file under "/etc/sysctl.d":

net.ipv6.conf.default.accept_redirects=0
This website is not created by, run, approved, or endorsed by the U.S. Department of Defense. Use at your own risk. This website is created by open-source software.